Advertisement
7. TROUBLESHOOTiNG
FAULT
1A) Pressure drop in the tank.
1B) Pressure drop in the tank.
1c) Pressure drop in the tank.
2) Pressure switch valve leaks when
compressor is idle.
3) Air leaks from tank body or tank welds.
4A) motor stops and will not restart.
4B) motor stops and will not restart.
5) compressor stops and does not restart.
6A) compressor does not stop at max. pressure.
6B) compressor does not stop at max. pressure.
7) compressor noisy with metallic knock.
8) excessive moisture in discharged air.
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
iNFORMATiON: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey limited
Air leaks at connections.
Air leaks from safety valve.
Air leaks from cylinder head gasket.
non-return valve seal defective.
Internal corrosion caused by infrequent tank
draining or non permitted modifications to tank.
thermal cut out has operated.
supply fuse has tripped.
Pressure switch fault.
Head gasket or valve fault.
Bearing or piston damage.
High humidity environment.
Sole UK distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk,
IP32 7Ar
Original Language Version
CAUSE
motor failure.
filter clogged.
WEEE Regulations.
dispose of this product at the end of its working life in compliance
with the eu directive on Waste electrical and electronic equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
01284 757500
01284 703534
REMEdY
run compressor to max. pressure, switch off
Brush soap solution over connections and look for
bubbles. tighten connections showing leaks.
If problem persists contact Authorised service Agent.
operate the safety valve manually by pulling on the
ring. If valve continues to leak when in the closed
position it should be replaced.
check tightness of head bolts. If leak continues
contact Authorised service Agent.
empty the air tank. referring to fig.6, remove the
non-return valve cap (3), spring (2) and seal (1).
clean the seal and its seat, or if necessary replace
the seal and refit.
tank could rupture or explode. cannot be repaired.
diSCONTiNUE USE iMMEdiATELY.
Allow unit to cool for 30 minutes before restarting.
reset fuse and restart unit. If repeated tripping
occurs, replace the check valve or contact
Authorised service Agent.
contact Authorised service Agent.
contact Authorised service Agent.
replace filter element.
contact Authorised service Agent.
contact Authorised service Agent.
drain tank after each use.
fig.6
www.sealey.co.uk
Web
sales@sealey.co.uk
email
sAc2420e110V.V2 Issue no:1 - 17/03/14
Advertisement
