Installing/Removing Line Modules - Siemens SIMATIC NET RUGGEDCOM RX1511 Installation Manual

Blank Modules
RUGGEDCOM RX1500PN PS XXP
RUGGEDCOM RX1500PN LM Blank
4.2

Installing/Removing Line Modules

Upon installing a new line module in the device, all features associated with the
module are available in RUGGEDCOM RX1511. For more information, refer to the
RUGGEDCOM ROX User Guide for the RUGGEDCOM RX1511.
Once a line module is removed, all the features associated with the module are hid-
den or disabled in RUGGEDCOM RX1511.
When installing more than one line module in the device, make sure the total power
consumption of all line modules does not exceed 41.5 W (i.e. the total power made
available to the modules by the chassis). If the total power consumption exceeds
this value, power fluctuations and irregular shut downs may occur.
For the maximum power consumption of each line module, refer to
ules (Page
NOTICE
Only one WAN line module is supported per chassis.
Contamination hazard – risk of equipment damage
Prevent the ingress of water, dirts and other debris that may lead to premature
equipment failure. Always make sure slots are not left empty and open ports are
protected with plugs or covers.
Removing a Module
To remove a line module, do the following:
1.
RUGGEDCOM RX1511
Installation Manual, 12/2019, C79000-G8976-1056-16
CAUTION
25)".
CAUTION
[Optional] If the device is installed in a rack, remove it from the rack.
4.2 Installing/Removing Line Modules
Specifications
—
Specifications
—
Modules
Article Numbers
6GK6015-0AL10-0AA0
(Standard)
6GK6015-0AL10-0AA1
(Conformal Coated)
Article Numbers
6GK6015-0AL20-0AA0
(Standard)
6GK6015-0AL20-0AA1
(Conformal Coated)
"Available Mod-
37