Fortinet FortiGate-7000E Series Manual page 24

Processing module

Hide thumbs Also See for FortiGate-7000E Series:

Table of Contents

Quick FIM-7901E configuration

MGMT 1 to MGMT 4 of each FIM-7901E are configured as a static aggregate interface called mgmt and all have the

same IP address. If you have two FIM modules installed in your chassis, then MGMT 1 to MGMT 4 of both modules are

all in the same static aggregate interface.

At any time during the configuration process, if you run into problems, you can reset the FIM-7901E to the factory

defaults and start over. From the CLI enter

Connect to the GUI by connecting MGMT1 of the module in slot 1 to your network and browsing to

https://192.168.1.99. Log into the GUI using the admin account with no password. Go to Network > Interface and

configure the FIM-7901E interfaces to connect to your network.

FIM-7901E Processing Module Guide

execute factoryreset .

Fortinet Technologies Inc.

Table of Contents

Need help?

Do you have a question about the FortiGate-7000E Series and is the answer not in the manual?

Fim-7901e