Troubleshooting; Fim-7901E Does Not Startup; Fim-7901E Status Led Is Flashing During System Operation - Fortinet FortiGate-7000E Series Manual

Hardware installation

Troubleshooting

This section describes some common troubleshooting topics:

FIM-7901E does not startup

Positioning of FIM-7901E mounting hardware and a few other causes may prevent a FIM-7901E from starting up
correctly.
Power sliders and module levers not fully closed
If the power sliders or module levers are damaged or positioned incorrectly, the FIM-7901E may not start up. Make sure
the sliders are fully closed and the levers are correctly aligned, fully inserted, and locked and the secure screws are
tightened.
Firmware problem
If the FIM-7901E is receiving power and the sliders are levers are fully closed, and you have restarted the chassis and
the FIM-7901E still does not start up, the problem could be with FortiOS. Connect to the FIM-7901E console and try
cycling the power to the board. If the BIOS starts up, interrupt the BIOS startup and install a new firmware image. See
your FortiGate-7000 chassis system guide for information about accessing and installing firmware on individual
modules.
If this does not solve the problem, contact Fortinet Technical Support.

FIM-7901E status LED is flashing during system operation

Normally, the FIM-7901E Status LED is off when the FIM-7901E is operating normally. If this LED starts flashing while
the module is operating, a fault condition may exist. At the same time the FIM-7901E may stop processing traffic.
To resolve the problem you can try removing and reinserting the FIM-7901E in the chassis slot. Reloading the firmware
may also help.
If this does not solve the problem there may have been a hardware failure or other problem. Contact Fortinet Technical
Support for assistance.
FIM-7901E Processing Module Guide
22
Fortinet Technologies Inc.