Table of Contents
Advertisement
Preparing the worktop
Create the worktop cut-out as shown
in the hob and inset diagrams. Re-
member to maintain the minimum
safety distances (see "Safety dis-
tances").
Solid wood and tiled worktops:
Secure the wooden frame 2 mm
below the top edge of the worktop
(see diagram).
Flush-fitted hobs
Install the hob
Feed the mains connection cable for
the hob down through the worktop
cut-out.
Centre the hob in the cut-out.
Connect the hob to the mains.
Connect the hob to the gas supply
(see "Gas connection").
Check that the hob works (see "Func-
tional check").
Secure the hob (see "Securing the
hob").
Seal the remaining gap with a silic-
one sealant that is heat-resistant to at
least 160 °C.
Unsuitable sealant can damage nat-
ural stone.
For natural stone worktops and nat-
ural stone tiles, only use silicone
sealant that is specially formulated
for natural stone.
Follow the manufacturer's instruc-
tions.
47
Advertisement
Table of Contents
