Table of Contents
Advertisement
RUGGEDCOM WIN5214
Installation Guide
Section 2.7.1
Connecting the RUGGEDCOM WIN1010
The RUGGEDCOM WIN1010 is a Power-over-Ethernet injector used to power the subscriber unit and distribute
data. The injector provides RJ45 input connectors that include 10/100Base-T transceivers for connection to an IEEE
802.3 (10/100Base-T) compatible device. It receives power from a 100 to 240 VAC power source using an IEC-320-
C14 industry standard connector.
CAUTION!
Electrical hazard – risk of damage to equipment. The power cord provided with the data adapter is
safety certified according to national rules. Do not use a power cord that has not been approved by
Siemens for use with the data adapter.
To connect power and data to the subscriber unit, do the following:
CAUTION!
Crushing hazard – risk of damage to equipment. Route all power supply cables so that people cannot
walk on them or place objects on or against them. This can pinch or damage the cords.
1.
Connect an indoor-to-outdoor CAT-5e cable to the Ethernet port on the injector. For information on cable
requirements, refer to
2.
Apply the PoE connector kit to the other end of the CAT-5e cable. For more information, refer to
Section 2.7.3, "Assembling the PoE
3.
Connect the modified end of the cable to the DC/ETH port on the subscriber unit.
Figure 6: Connecting the RUGGEDCOM WIN1010 PoE Injector
1. Subscriber Unit 2. PoE Cable 3. Switch or Router 4. Ethernet 5. RUGGEDCOM WIN1010 6. AC Power Cable 7. AC Power
4.
Connect a CAT-5e cable between the RUGGEDCOM WIN1010 and a 10/100Base-T port of a switch or router.
5.
Make sure all system components are properly installed and all cable connectors are securely positioned in
the appropriate ports.
6.
Connect the data adapter to the 110/220 VAC mains.
Connecting the RUGGEDCOM WIN1010
Section 4.5, "IDU to ODU Cable
Connector".
1
Specifications".
2
3
4
4
5
6
Installing the Subscriber Unit
7
Chapter 2
15
Advertisement
Table of Contents
