Table of Contents
Advertisement
2.12 Cleaning and disinfection of beds
Notices: the products are not applicable to using "Spraying stream" cleaning
machines or high pressure and high steam to clean. During the cleaning, do not
use the water to sprinkle the beds directly, especially for the electrical parts.
Cleaning of the beds：
1. For cleaning completely and convenient checking after cleaning, please lift up the
whole bed to the highest position, including back and leg sections.
2. Please take away the mattress and bed sheet, pull out the power supply wire from
the socket and wreathe on the electric wire rack.
3. When cleaning, please wipe the bed with the wrested dry cloth which has been
dipped into the diluted neutral scour, then dip the clean cloth into the clean water and
wrest dry to wipe away the residual scour, finally dried with clean dry cloth.
4. Please do not use volatile chemicals to clean, such as thinner, volatile liquid,
gasoline and so on. Or else it will cause the materials to change colors or the quality
change.
Disinfection of the beds：
1. When disinfection, please use the below disinfector which has been diluted with the
appointed proportion to disinfect.
0.05-0.2%
ammonium chloride disinfector
0.05-0.2%
chlorophenyl disinfector
0.05%
chlorhexidine liquid
2. According to the difference of the disinfector, there may make the metal parts
corrupted or the plastic parts turned colors, quality change, split, so please use the
above recommended disinfectors.
3. Please confirm well the ingredients of the disinfector before disinfection.
4. After finish disinfection, please wipe away the disinfector.
5. Don't use the Ozone machine and autoclave as disinfectors for the bed.
2.13 Malfunction and elimination methods
Common malfunctions
The controller can't work.
It's difficult to move the whole
bed.
Bedside rail is easy to loose
and fall off
The sound is too noisy when
the bed up or down
HOPEFULL
®
electric bed Instruction for use
Possible reasons
Forget to connect the power or
the wire can't connect well.
Brake system is locked, all castors
are locked.
Bedside rail is not in the standard
risen position.
Movement parts are not enough
lubricative
16
Elimination methods
Connect
the
electric
again.Make
sure
indicator light is on.
Unlock the brake system
Lift the bedside rail upwards again,
loose hands when hear "ka"
Please add lubricative oil at the
each connecting joints of movement
parts
wire
the
power
Advertisement
Table of Contents
