Advertisement
®
With EchoPod
connected to your computer, open the WebCal
Follow steps 1-4 to configure the transmitter. Click "Help" in the lower right hand corner and open the help
®
menu of WebCal
for instructions on WebCal
contact a Flowline applications engineer at (562) 598-3015. * For complete information on the WebCal
software, please refer to the WebCal
CONFIGURING ECHOPOD
1. Output Configuration
a. Configures the relays in terms of pump/valve operations as well as high or low alarms.
b. Sets fail-safe for the relays and the sensor's output (current, voltage or frequency).
2. Tank Shape Selection
a. Defines the shape of the tank as well as the dimensional information for the tank with
3. Tank Level Configuration
a. Enters the settings for the relay activation points as well as confirms the operational
4. Write to Unit
a. Uploads the configuration into the sensor.
b. Provides a custom wiring diagram specific to the signal output and/or relay configuration.
OUTPUT CONFIGURATION:
Configures the relays in terms of pump/valve operations and level alarms as well as the setting fail-safe for
relays and signal output.
|
4
®
manual located at flowline.com/webcal.
®
®
WITH WEBCAL
respect to the sensor's location on the tank.
range.
®
* software by clicking on the WebCal
®
. If you need additional assistance using WebCal
®
icon.
®
, please
®
QS204210 Rev C
Advertisement
