Configuring The Sensor; Configuration Menu - FlowLine LU74 EchoSwitch II Quick Start Manual

Configuring the Sensor

The sensor
features non-volatile memory, and can be configured prior to installation.
Your configuration will not be lost when the transmitter is powered down.
Before configuring, be sure to have the following
information:
Height. This is the distance from the transducer
face to the bottom of the tank.
Fill Height (Fill-H). This is the distance from
the highest level of liquid to the bottom of the
tank

Configuration Menu

The sensor is configured with the three button's on the
sensor face (UP, DOWN and SELECT) and the sensor's
LCD. To access the sensor's configuration menu, simply
hold down the SELECT button for five seconds or until the
menu is displayed. The display menu will automatically
begin to scroll through the uppermost level of the
configuration menu.
When the menu scrolls to an item you wish to configure, simply press the SELECT
button again when that item appears. Once you've made your configuration changes,
press SELECT again to scroll through the options and once more while RUN appears
in the display. This will return the sensor to its operational mode.
To go up one level, press SELECT when EXIT appears.
We do Your Level Best
Height and Fill Height
®
The EchoSwitch II
Interface
Set Units
®
The EchoSwitch II displays information
in either inches, feet, centimeters, meters
or percentages. This can also be displayed
to represent the amount of air or liquid in a
tank.
Air Display Mode shows the distance from the
bottom of the sensor to the liquid surface. Liquid Display
mode show the distance from the liquid
surface to the bottom of the tank.
Follow these instructions to set how units are displayed:
1) Enter the Configuration menu (as discussed previously),
2) Select UNITS from the menu,
3) Select the type of unit or the type of DISPLAY you desire, and
4) Select EXIT to return to the Configuration menu.
Set Height and Fill Height
This setting customizes the reading for your installation. Follow these instructions to
set the height and fill height for your tank:
1) Enter the Configuration menu (as discussed previously), and press SELECT
when TANK appears.
2) Select HEIGHT. Use the UP and DOWN buttons to set the height of your
tank. Then, hold down the SELECT button to save this setting.
3) Select FILL-H for the fill height. Use the UP and DOWN buttons to set the fill
height of your tank. Then, hold down the SELECT button to save this setting.
4) Select EXIT to return to the Configuration menu.
Setting Units
We do Your Level Best