Kenwood DDX919WS Instruction Manual page 93

Ñ
3-way speaker system setup
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
+
White/Black
Gray
+
Gray/Black
Green
+
Green/Black
Purple
+
Purple/Black
Speaker impedance: 4-8 Ω
NOTE
• For speaker system setup, see 3-way speaker
system setup (P.73).
• For speaker setup and crossover setup, see
Speaker / X'over setup (P.74).
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.93) and Connecting
wires to terminals (P.91).
Speaker
To mid range left
speaker
To mid range right
speaker
To tweeter left speaker
To tweeter right
speaker
Ñ
Connecting the system and
external components
12 11 10
1
2
3
4
5
HDMI input
1
(Except DMX8019S)
Use HDMI cable KCA-HD100 (optional
accessory).
When you connect the cable to HDMI terminal,
remove the fixture. After connecting the cable,
put the fixture again.
2 Accessory ! : DAB antenna
(DDX9019DABS / DMX8019DABS only)
3 AV Audio output (ø3.5 mini jack)
4 FM/AM antenna input
When connecting to an external amplifier,
5
connect its ground wire to the car's chassis to
avoid damaging the unit.
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Subwoofer Preout
(Left; White, Right; Red)
Connection/Installation
15
14
13
9 8 7 6
Fixture
HDMI connector
English
93