Kenwood DDX919WS Instruction Manual page 88

Monitor with receiver
Table of Contents

Advertisement

Connection/Installation
Ñ
Microphone unit
1) Check the installation position of the
microphone (accessory 4).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 4), and stick the microphone to
the place shown below.
4) Wire the microphone cable up to the unit
with it secured at several positions using tape
or other desired method.
5) Adjust the direction of the microphone
(accessory 4) to the driver.
4
Fix a cable with a commercial item of tape.
Ñ
Detaching the trim plate
(DDX9019DABS / DMX8019DABS /
DMX8019S)
1) Detach accessory 7 to the unit.
7
Ñ
Installation the Digital Radio
antenna
(DDX9019DABS / DMX8019DABS)
#CAUTION
• This film antenna is exclusively for use inside the
vehicle.
• Do not install at the following locations:
– Where it may block driver's view
– Where it may obstruct operation of safety devices
such as air bags
– On movable glass surface such as rear hatch
– On the side of the vehicle (e.g. doors, front-side
windows)
– On rear windows
88
• Signal strength will decrease at the following
locations:
– On IR reflecting glass or where covered with mirror
type glass film
– Where it overlaps with genuine radio antenna
(pattern)
– Where it overlaps with window heating wires
– When glass that blocks radio signals (e.g. IR
reflecting glass, thermal insulation glass) is used
• Poor reception may occur:
– Due to noise when the windshield wipers, air
conditioner, or motor is turned on
– Depending on the location of the broadcast station
in relation to the vehicle (antenna)
• Thoroughly wipe oil and dirt from the pasting surface
with the included cleaner (accessory =).
• Do not bend or damage the film antenna (accessory
~).
• It may not be possible to install on some type of
vehicle.
• Check the cable routing of the film antenna (accessory
~) and amplifier (accessory !) before pasting.
● Installation overview
The antenna should be installed on the
passenger side for safety.
● Determining the antenna installation
location
• The direction of the film antenna (accessory ~)
changes depending on whether the film antenna is
installed on the right side or left side.
• Be sure to check the installation location of the film
antenna (accessory ~) before installing. The film
antenna cannot be reattached.
• Install the antenna at least 100 mm away from other
antennas.
• Do not attach the amplifier unit (accessory !) to the
ceramic line (black part) around the windscreen, as it
will not stick sufficiently.
~ !
Antenna cable
(3.5 m)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents