Pillow Care; Draining; Winterizing; Special Cold Weather Instructions - Dimension One Spas BAY Series Owner's Manual

13.4

Pillow Care

Remove and clean the headrest pillows, as needed, with soapy water us-
ing a cloth or soft-bristle brush. Always remove the pillows when adding
chemical shock treatment to the spa water. The pillows can be returned
to the spa when the sanitizer reading is stable as recommended.
13.5

Draining

IMPORTANT: Keep the hot tub covered when empty of water. Sun-
light and extreme cold can damage the surface and cause it to peel
or blister.
1. Turn power OFF!
2. Locate the hose bib, at the bottom of the hot tub, Figure 13.7a. Make
sure that the valve is in the OFF position.
3. Unscrew the cap from the spa drain, Figure 13.7b.
4. Attach one end of your garden hose to the drain valve, Figure 13.7c.
Place the other end in an area safe for water runoff.
5. Turn the hose bib switch to the open position to release the water,
Figure 13.7d.
6. Once the hot tub is drained, turn the switch back to the closed
position, remove the hose and reinstall the cap.
Figure 13.5a
13.6

Winterizing

All D1 spas are designed for year-round use. Your hot tub has an
automatic freeze protection mode to circulate water during freezing
weather, assuming the system has electrical power and the proper water
level. However, if freezing weather prohibits normal use, an authorized
service provider should winterize your hot tub. Draining the unit will
not prevent freeze damage, as small amounts of water in the plumbing
can expand and damage the system. Winterizing the unit is specifically
not covered by the manufacturers' warranty, so you should contact a
professional to both winterize and restart your hot tub if necessary.
Freeze damage caused by winterizing your system is specifically not
covered by your warranty.
13.7

Special Cold Weather Instructions

The system has a "Smart Winter" freeze protection mode to circulate
water during freezing weather, assuming the system has electrical power
and the proper water level. It will automatically activate the pump(s) to
circulate water. This is a normal hot tub function. No corrective action is
necessary. This feature protects the spa from freezing.
Figure 13.5b
BAY Collection
Figure 13.5c Figure 13.5d
Page 41