Gtech MULTI ATF036 Operating Manual page 13

Re-insert the brush bar, starting by the end
furthest away from the button. Then line
up and push the brush bar into the AirRam
until it clicks into place.
Clearing a jam / fault
If the brush bar jams during use, the
AirRam will stop and the LEDs will appear
red. You will need to remove and clean the
brush bar (see page 11).
2859_System_TE_manual_update_aw.indd 13
Replace the battery by sliding it down into
the head assembly. It will click into place.
10
seconds
The AirRam will not re-start until the red
lights go out. This will take ten seconds.
If the problem persists, follow the
troubleshooting instructions below.
13
31/05/2018 13:24