Starting / Stopping The Engine; Break / Lubricant - Bushranger BRUZCS5210 Operator's Manual

USING THE PRODUCT
STARTING WITH A WARM ENGINE (continued)
• Turn ignition switch up to on position.
• Securely hold the chain saw.
• Pull starter handle.
• Choke may be used if necessary but after first firing sound, pull throttle trigger a little to release throttle latch and
choke.
WARNING
Clutch engages chain and will rotate when engine is started with throttle trigger squeezed. After engine starts release
throttle trigger to idle position.
RUNNING
• After engine starts, allow it to idle for a few minutes.
• Squeeze throttle trigger gradually to increase engine revolution.
• The chain starts moving when the engine reaches 3,800 r/min approximately.
• Ensure proper acceleration and lubrication of saw chain and guide bar.
• Do not run the engine at high speed unnecessarily.
• Be sure that saw chain stops moving when throttle trigger is released.
STOPPING THE ENGINE
• Release throttle trigger and turn ignition switch down.
NOTE:
If engine does not stop, pull choke control knob all the way out to
stop engine. Check and repair ignition switch before starting the engine
again.
CHECKING CHAIN TENSION
• Chain tension should be checked frequently during work and corrected if necessary. Fig 10.
• Tension the chain as tight as possible, but so it can still be pulled easily along the bar by hand.
WARNING
Make sure that the engine is shut off when checking chain tension.
CHECKING THE BRAKE FUNCTION
• Place the chain saw on the ground.
• Hold the handle with both hands and accelerate the engine to high speed by throttle trigger.
• Operate the chain brake by turning your left wrist against the front hand guard during your grip on the front handle.
12
• The chain starts moving when the engine
reaches 3,800 r/min approximately.
• Ensure proper acceleration and lubricatio
of saw chain and guide bar.
• Do not run the engine at high speed
unnecessarily.
• Be sure that saw chain stops moving whe
throttle trigger is released.
STOPPING THE ENGINE
STOPPING THE ENGINE
• Release throttle trigger and turn ignition
STOPPING THE ENGINE
switch down.
•Release throttle trigger and turn ignition switch down.
•Release throttle trigger and turn ignition swi
NOTE
NOTE
STOPPING THE ENGINE
• When engine does not stop, pull choke
NOTE
When engine does not stop, pull choke control knob
control knob all the way out to stop engin
•Release throttle trigger and turn ignition swi
When engine does not stop, pull choke contr
all the way out to stop engine.
all the way out to stop engine.
Check and repair ignition switch before starting the
• Check and repair ignition switch before
NOTE
Check and repair ignition switch before starti
engine again.
starting the engine again.
When engine does not stop, pull choke contr
engine again.
Fig. 10
all the way out to stop engine.
Check and repair ignition switch before starti
engine again.
CHECKING CHAIN TENSION
CHECKING CHAIN TENSION
CHECKING CHAIN TENSION
• Chain tension should be checked
•Chain tension should be checked frequently during
frequently during work and corrected if
•Chain tension should be checked frequently
work and corrected if necessary.
necessary.
work and corrected if necessary.
•Tension the chain as tight as possible, but so it can CHECKING CHAIN TENSION
•Tension the chain as tight as possible, but so
still be pulled easily along the bar by hand.
• Tension the chain as tight as possible, bu
•Chain tension should be checked frequently
still be pulled easily along the bar by hand.
so it can still be pulled easily along the ba
work and corrected if necessary.
by hand.
MAKE SURE THAT THE ENGINE IS SHUT OFF
•Tension the chain as tight as possible, but so
MAKE SURE THAT THE ENGINE IS SHUT OFF
WHEN CHECKING CHAIN TENSION.
still be pulled easily along the bar by hand.
WARNING DANGER
WHEN CHECKING CHAIN TENSION.
Make sure that the engine is shut off when
checking chain tension.
MAKE SURE THAT THE ENGINE IS SHUT OFF
12
WHEN CHECKING CHAIN TENSION.
CHECKING THE BRAKE FUNCTION OF
CHECKING THE BRAKE FUNCTION
THE BRAKE
THE BRAKE
Ignition switch
Throttle trigger lockout
WARNING ▲ DANGER
WARNING ▲ DANGER
WARNING ▲ DANGER
Throttle trigger