Bushranger BRUZCS5210 Operator's Manual page 11

USING THE PRODUCT
CHAIN LUBRICATION
Proper lubrication of the chain while in operation reduces the friction between the chain and the guide bar or a minimum
and assure a longer life time. Use only special chain oil of high quality for this purpose. Do not use any waste or reclaimed
oil to avoid various problems with the oil pump. In case of emergency it is allowed to use motor oil for a short time.
STARTING THE COLD ENGINE
• Fill the fuel tank with 2 stroke fuel. Fig 9 - A.
• Fill the chain oil tank with bar and chain lubricant. Fig 9 - B.
• Press hand guard forward. (Chain brake ACTIVATED position).
• Turn ignition switch up to on position
• Pull choke control knob all the way out.
• Securely hold the chain saw.
• Make sure guide bar and saw chain are not touching anything when starting the saw.
• Pull starter handle several times until first firing sound is heard.
• Push choke control knob all the way in.
• Pull starter handle again until engine starts and runs.
WARNING
• After choke control knob is pulled and then knob is returned to original position, throttle remains a little open (latch
condition).
• If engine is started in this latch condition, chain starts to turn. DO NOT start engine before chain brake is activated.
NOTE:
Do not pull starter rope out to the maximum position as it will damage starter. Do not allow starter handle to snap
back against the casing.
WARNING
• After starting the engine, squeeze trigger slightly to release throttle latch and pull front hand guard towards the operator
immediately. (Chain brake RELEASED position).
• Do not increase engine speed while chain brake is engaged.
• Use the chain brake in an emergency. Do not use it unless absolutely necessary.
• When throttle latch is used, saw chain will go into motion as soon as the engine starts. Never use throttle latch for
cutting. Use it only when starting the engine.
STARTING WITH A WARM ENGINE
• Confirm fuel and chain oil in the tanks.
• Press hand guard forward. (Chain brake ACTIVATED position).
Fig. 9
(B)
Starter Handle
(A)
11