Configuring Traffic Logging For Connections To An Interface; Configuring The Wan1 And Wan2 Interfaces With A Static Ip Address; Configuring The Wan1 Or Wan2 Interfaces For Dhcp - Fortinet FortiGate FortiGate-60R Installation And Configuration Manual

Configuring interfaces

Configuring traffic logging for connections to an interface

Configuring the wan1 and wan2 interfaces with a static IP address

Configuring the wan1 or wan2 interfaces for DHCP

110
1 Go to System > Network > Interface.
2 Select Modify
3 Select Log to record log messages whenever a firewall policy accepts a connection to
this interface.
4 Select OK to save your changes.
Figure 1: Configuring the internal interface
1 Go to System > Network > Interface.
2 For the wan1 or wan2 interface, select Modify
3 Set Addressing mode to Manual.
4 Change the IP address and Netmask as required.
5 Select OK to save your changes.
Use the following procedure to configure the wan1 or wan2 interface to use DHCP.
This configuration is required if your ISP uses DHCP to assign the IP address of the
wan1 or wan2 interface.
1 Go to System > Network > Interface.
2 For the wan1 or wan2 interface, select Modify
3 Set Addressing mode to DHCP and select OK to change to DHCP mode.
Both the IP address and Netmask change to 0.0.0.0.
for the interface for which to configure logging.
Network configuration
.
.
Fortinet Inc.