Fortinet FortiGate FortiGate-60 Administration Manual page 52

Interface
10
12
52
Select Apply.
The FortiGate unit attempts to contact the PPPoE server from the interface to set the
IP address, netmask, and optionally default gateway IP address and DNS server IP
addresses.
11 Select Status to refresh the addressing mode status message.
Select OK.
To add a secondary IP address
You can use the CLI to add a secondary IP address to any FortiGate interface. The
secondary IP address cannot be the same as the primary IP address but it can be on
the same subnet.
From the FortiGate CLI, enter the following commands:
config system interface
edit <intf_str>
config secondaryip
edit 0
set ip <second_ip> <netmask_ip>
Optionally, you can also configure management access and add a ping server to the
secondary IP address:
set allowaccess ping https ssh snmp http telnet
set gwdetect enable
Save the changes:
end
To add a ping server to an interface
1 Go to System > Network > Interface.
2 Choose an interface and select Edit.
3 Set Ping Server to the IP address of the next hop router on the network connected to
the interface.
4 Select the Enable check box.
5 Select OK to save the changes.
To control administrative access to an interface
For a FortiGate unit running in NAT/Route mode, you can control administrative
access to an interface to control how administrators access the FortiGate unit and the
FortiGate interfaces to which administrators can connect.
01-28006-0002-20041105
System network
Fortinet Inc.