Fortinet FortiGate FortiGate-60 Administration Manual page 142

Static
142
For example, consider
To ensure that all outbound packets destined to any network beyond the router are
routed to the correct destination, you must edit the default configuration and make the
router the default gateway for the FortiGate unit.
Figure 52: Making a router the default gateway
192.168.10.1
FortiGate_1
Internal network
192.168.20.0/24
To route outbound packets from the internal network to destinations that are not on
network 192.168.20.0/24, you would edit the default static route and include the
following settings:
• Destination IP/mask: 0.0.0.0/0.0.0.0
• Gateway: 192.168.10.1
• Device: Name of the interface connected to network 192.168.10.0/24 (e.g.
external).
• Distance: 10
The Gateway setting specifies the IP address of the next hop router interface to the
FortiGate external interface. The interface behind the router (192.168.10.1) is
the default gateway for FortiGate_1.
In some cases, there may be routers behind the FortiGate unit. If the destination IP
address of a packet is not on the local network but is on a network behind one of those
routers, the FortiGate routing table must include a static route to that network. For
example, in Figure 53, the FortiGate unit must be configured with static routes to
interfaces 192.168.10.1 and 192.168.10.2 in order to forward packets to Network_1
and Network_2 respectively.
01-28006-0002-20041105
Figure 52, which shows a FortiGate unit connected to a router.
Internet
Router
external
Esc Enter
Router
Fortinet Inc.