Getting started
Next steps
FortiGate-60M Installation Guide
If you are configuring the FortiGate unit to operate in Transparent mode, you can
switch to Transparent mode from the web-based manager and then use the setup
wizard to add the administration password, the management IP address and gateway,
and the DNS server addresses.
Now that your FortiGate unit is operating, you can proceed to configure it to connect to
networks:
•
If you are going to operate the FortiGate unit in NAT/Route mode, go to
"NAT/Route mode installation" on page
•
If you are going to operate the FortiGate unit in Transparent mode, go to
"Transparent mode installation" on page
•
If you are going to operate two or more FortiGate units in HA mode, go to
availability installation" on page
01-28008-0111-20050128
29.
41.
49.
Next steps
"High
27
Need help?
Do you have a question about the FortiGate FortiGate-60M and is the answer not in the manual?