Zone - Fortinet FortiGate FortiGate-300 Administration Manual

System network

Zone

FortiGate-300 Administration Guide
To configure administrative access in Transparent mode, see
management interface" on page
1 Go to System > Network > Interface.
2 Choose an interface and select Edit.
3 Select the Administrative Access methods for the interface.
4 Select OK to save the changes.
To change the MTU size of the packets leaving an interface
1 Go to System > Network > Interface.
2 Choose an interface and select Edit.
3 Select Override default MTU value (1500).
4 Set the MTU size.
Note: You cannot set the MTU of a VLAN larger than the MTU of its physical interface. Nor can
you set the MTU of a physical interface smaller than the MTU of any VLAN on that interface.
To configure traffic logging for connections to an interface
1 Go to System > Network > Interface.
2 Choose an interface and select Edit.
3 Select the Log check box to record log messages whenever a firewall policy accepts a
connection to this interface.
4 Select OK to save the changes.
You can use zones to group related interfaces and VLAN subinterfaces. Grouping
interfaces and VLAN subinterfaces into zones simplifies policy creation. If you group
interfaces and VLAN subinterfaces into a zone, you can configure policies for
connections to and from this zone, rather than to and from each interface and VLAN
subinterface.
You can add zones, rename and edit zones, and delete zones from the zone list.
When you add a zone, you select the names of the interfaces and VLAN subinterfaces
to add to the zone.
Zones are added to virtual domains. If you have added multiple virtual domains to
your FortiGate configuration, make sure you are configuring the correct virtual domain
before adding or editing zones.
60.
01-28006-0005-20041105
Zone
"To configure the
57