Regulations And Standards - Oriental motor AZM14*K Series Operating Manual

Regulations and standards

4 Regulations and standards
4-1 EU Directive
 CE Marking
This product is affixed the CE Marking under the EMC Directive.
 Low Voltage Directive
The input power supply voltage of this product is 24 VDC/48 VDC. Therefore this product is not subject to the Low
Voltage Directive, but install and connect it as follows.
 This product is designed and manufactured to be incorporated in equipment. Install the product in an enclosure.
 For the driver power supply, use a DC power supply with reinforced insulation on its primary and secondary sides.

EMC Directive
This product is conducted EMC measurements in accordance with "Example of motor and driver installation and
wiring" on p.24. The conformance of your mechanical equipment to the EMC Directive will vary depending on such
factors as the control system equipment used with this product, confi guration of electrical parts, wiring and layout. It
therefore must be verified through conducting EMC measures in a state that all parts including this product have
been installed in the equipment.
Applicable Standards
EN 55011 Group1 Class A
EMI
EN 61000-6-4
EMS EN 61000-6-2
Combinations with the motor and driver that can conform to the EMC Directive
Characters that the series name and product type can be discriminated are described in the motor model name.
Check the motor model name with the nameplate.
Type
Built-in controller type
Pulse input type with RS-485
communication interface
Pulse input type
4-2 Republic of Korea, Radio Waves Act
This product is affi xed the KC Mark under the Republic of Korea, Radio Waves Act.
4-3 RoHS Directive
The products do not contain the substances exceeding the restriction values of RoHS Directive (2011/65/EU).
▌8
This equipment is not intended for use in residential environments nor for use on a low-
voltage public network supplied in residential premises, and it may not provide
adequate protection to radio reception interference in such environments.
Driver
Driver model
AZD-KD
AZD-KX
AZD-K
Motor
Type
AZM14K-
AZM15K-
AZM24K-
AZM26K-
Standard type
AZM46K-
Geared type
AZM48K-
AZM66K-
AZM69K-
Motor model