Factory Default Nat/Route Mode Network Configuration - Fortinet FortiGate FortiGate-3000 Install Manual

Factory default NAT/Route mode network configuration

26
When the FortiGate unit is first powered on, it is running in NAT/Route mode and
has the basic network configuration listed in
configuration enables you to connect to the FortiGate unit web-based manager
and establish the configuration required to connect the FortiGate unit to the
network. In Table 6 on page
connect to the web-based manager using HTTPS protocol through this interface.
Ping administrative access means this interface responds to ping requests.
Table 6: Factory default NAT/Route mode network configuration
Administrative User name:
account
Password:
IP:
Internal Interface Netmask:
Administrative Access:
IP:
External Interface Netmask:
Administrative Access:
IP:
Port 1 Netmask:
Administrative Access:
IP:
Port 2 Netmask:
Administrative Access:
IP:
Port 3 Netmask:
Administrative Access:
IP:
Port 4 Netmask:
Administrative Access:
Port 4/HA and IP:
Port 5/HA Netmask:
Administrative Access:
Default Gateway (for default route)
Interface connected to external network
(for default route)
Default Route
A default route consists of a default gateway and the name of the
Network Settings
interface connected to the external network (usually the Internet).
The default gateway directs all non-local traffic to this interface
and to the external network.
Primary DNS:
Secondary DNS:
FortiGate-3000 and FortiGate-3600 FortiOS 3.0MR4 Install Guide
Table 6 on page
26, HTTPS administrative access means you can
Factory defaults
26. This
admin
(none)
192.168.1.99
255.255.255.0
HTTPS, Ping
192.168.100.99
255.255.255.0
Ping
0.0.0.0.
0.0.0.0
Ping
0.0.0.0.
0.0.0.0.
Ping
0.0.0.0.
0.0.0.0.
Ping
0.0.0.0.
0.0.0.0.
Ping
0.0.0.0.
0.0.0.0.
Ping
192.168.100.1
external
65.39.139.53
65.39.139.63
01-30004-0270-20070215