Snap Disc Replacement; Door Handle Assembly; Secondary Tube & Baffl E Board Removal - Quadra-Fire EXPLR-III-PBK Owner's Manual

C. Snap Disc Replacement
(included with optional blower)
1. Unplug the unit.
2. Locate the snap disc bracket assembly at the bottom left
rear corner of the stove (see page 12).
3. A magnet holds the bracket to the stove. Pull the bracket
down away from the stove to expose the snap disc.
4. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 19.1
5. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
6. Push the snap disc and spade connectors back inside
bracket. Reassemble in reverse order.
Snap Disc
Magnet
Figure 19.1
D. Door Handle Assembly
1. Slide door handle through door.
2. Install additional washer(s) as shown in Figure 19.2
3. Install key in groove.
4. Align groove in latch cam with key; slide latch cam over
shaft
5. Install locknut but do not overtighten, the handle needs
to rotate smoothly.
6. Install fi ber handle. Figure 19.2
CAUTION
Do not overtighten lock nut. The door handle needs to
move smoothly.
Door Cross
Latch Cam Section
Locknut
Spacing
Washers
Figure 19.2
February 25, 2016
Spade
Connectors
Door Handle Shaft
Square Key
Fiber Handle
E. Secondary Tube & Baffl e Board Removal
Be sure to soak with penetrating oil for 15 to 20 minutes
before trying to remove the bolts. Remove the 6 bolts, 3 of
which are shown in Figure 19.3, from bottom of baffl e as-
sembly as shown using 5/32" allen wrench.
Figure 19.3
7060-227D
Explorer III Wood Stove
19