Draytek Vigor2765 Series Quick Start Manual page 21

3. Set the Enable option for WAN2 to Yes, this enables the other options on
this page.
Set the Active Mode to Always On to make the Ethernet port the active
Internet connection.
4. Click OK to apply the change and the router will prompt to restart. Click OK
to restart the router.
Once the router has restarted, the WAN2 – Ethernet WAN interface can be
configured on the router, as shown in the following two sections.
Note To reconfigure port P4 for LAN use, go to [WAN] > [General
Setup] > [WAN2] and set the Enable option to No.
Once the router has been restarted to apply the change, the
port will operate in LAN mode.
17