Television Setup - Focus TView PresoCard User Manual

FOCUS Enhancements TView PresoCard User's Manual
CONNECTING TO YOUR TELEVISION
16
You will need either an S-Video cable or Composite Video
cable to connect your TView PresoCard to your television.
Step 1: Look at your TVs Video Input ports. Identify
whether your TV has an S-Video input, a Comp. Video
input or an RF input.
A. If your TV has an S-Video input, attach one end of
the S-Video cable to the S-Video port on your TView
PresoCard cable and attach the other end to the S-Video
input port on your television.
B. If your TV has an Comp. Video input, attach one end
of the Comp. Video cable to the Comp. Video port on
your TView PresoCard cable and attach the other end
to the Comp. Video Input port on your television.
C. If your TV has an RF input but no other inputs, you
must utilize a VCR with Comp. Video or S-Video input.
If you do not have a VCR with Comp. Video or S-Video
input, you must obtain an RF Modulator from Radio
Shack (part number 15-1283, see "RF Modulators,
VCRs, and You" in the Reference section at the end of
this manual).
You may use both S-Video and RCA outputs at the same
time (to send video to two televisions, for example).
Step 2: If desired, connect your computer monitor's 15-pin
cable to the 15-pin VGA Pass-through port on the
TView PresoCard cable.
Step 3: Turn on your Television. Set your TV to "AUX" or
"Video Input." Video In can usually be set by remote
control, with a button labeled TV/Video, Line In, Input
Select, Video, AUX, or similar. Sometimes Video selec-
tion takes place in an onscreen menu system.You must
make sure to set your TV to an Input channel instead of
a numbered channel, such as channel 3, because chan-
nel 3 is an RF channel, not a Video channel (RF
Modulator and VCR users should leave the TV on