Connecting To The Television Using An Rf Modulator - Focus TView Micro XGA User Manual

TView Micro XGA User's Guide
Connecting to the Television Using an
RF Modulator
If you do not have a television with composite video or S-Video, you
will need a special adapter called an RF Modulator. This device
converts the Composite Video signal from the TView Micro XGA unit
to an antenna signal. The RF Modulator is not supplied.
Note: When using an RF Modulator, the TV may have to be set
to a particular channel (for instance, 3 or 4) to accept the
TView Micro XGA 's video. Or, in some cases, you may
have to specify input using the TVs on-screen-
programming feature. If you are unsure about how to set
your television to accept external video through the
Antenna In, refer to the television owner's manual.
To connect the TView Micro XGA to your television
using the RF Modulator, perform the following steps:
1. Connect the RF Modulator to the coaxial input at the rear of the
television.
2. Connect one end of the composite video cable to the port
labeled "Comp Video" on the side of the TView Micro XGA unit.
3. Connect the other end of the composite video cable to the RF
Modulator's Composite Input at the rear of the television.
4. Plug RF modulator into wall outlet or surge protector
5. Turn your computer on.
6. Turn the TView Micro XGA on.
18 Hardware Installation