Connectors And Slots - Biostar P4M900-M7 SE Setup Manual

2.4 C
ONNECT ORS AND
FDD1: Floppy Disk Conne ctor
The motherboard prov ides a standard floppy disk connector that supports 360K,
720K, 1.2M, 1.44M and 2.88M floppy disk ty pes. This connector supports the
prov ided f loppy drive ribbon cable.
IDE1/IDE2: Hard Disk Conne ctors
The motherboard has a 32-bit Enhanced PCI IDE Controller that prov ides PIO
Mode 0~4, Bus Master, and Ultra DMA 33/66/100/133 f unctionality. It has two
HDD connectors: IDE1 (primary ) and IDE2 (secondary ).
The IDE connectors can connect a master and a slav e driv e, so you can
connect up to four hard disk drives. The f irst hard drive should always be
connected to IDE1.
P4M900-M7 SE/P4M890-M7 TE
S
LOT S
2
1
40 39
2 1
IDE1 IDE2
34
33
11