Smart Card Reader - HP ZBook 14U G5 Maintenance And Service Manual

Smart card reader

Description
Smart card reader
Smart card reader cable (available in Cable Kit)
Before removing the card reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the smart card reader:
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
inserted in the reader.
1. Disconnect the system board cable from the connector on the smart card reader board (1).
2. Disconnect the TouchPad cable from the ZIF connector on the smart card reader board (2).
3. Remove the three Phillips M2.0x2.5 screws (3) that secure the smart card reader to the computer.
4. Remove the smart card reader from the computer (4).
Reverse this procedure to install the smart card reader.
64 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page 49).
36).
Spare part number
L18312-001
L14370-001 (Cable Kit)