Table of Contents
Advertisement
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
6
Flat head
wood screw
%
Battery cover
$
Flat head wood screw
3
The provided Remote Controller is a
wireless type, which also can be used
as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.
Remark :
• Detail of accessory and installation
parts can see in the accessory sheet.
• Some pictures might be different from
the actual parts.
Optional Installation Parts
Part
Parts name
code
Refrigerant piping
A
Liquid side : ∅9.52 mm
: ∅15.88 mm
Gas side
Pipe insulating material
B
(polyethylene foam, 8 mm thick)
C
Putty, PVC tapes
6
Flat head
wood screw
Batteries
2
Wireless remote control
Q'ty
One
each
1
One
each
Hook
1
Installation
plate
Shield pipe
4
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available,
provided by installer)
Fixing bolt arrangement of outdoor unit
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be exposed
to a strong wind.
• Use ∅10 mm anchor bolts and nuts.
150
Drain nipple mounting hole
3
For the rear left and left piping
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose to get
slack.
Make sure to run the drain hose
sloped downward.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Rear
Bottom right
left
Insulate the refrigerant pipes
separately with insulation, not
together.
8 mm thick heat resisting
polyethylene foam
Drain hole
525
600
150
Drain hole
Wall
Cut the piping
hole sloped
slightly.
Left
Bottom left
Hide quick links:
Advertisement
Table of Contents
