Installation Diagram Of Indoor And Outdoor Units; Optional Installation Parts - Toshiba RAS-B10N4KVRG-E1 Installation Manual

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS

5
Flat head
7
wood screw
Remote controller
4
holder
Wireless
2
remote controller

Optional Installation Parts

Part
Parts name
code
Refrigerant piping
Liquid side : Ø6.35 mm
Gas side : Ø9.52 mm
(RAS-B10N4KVRG-E1)
A
(RAS-B13N4KVRG-E)
: Ø12.70 mm
(RAS-B16N4KVRG-E)
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
C Putty, PVC tapes
Hook
Mounting
6
screw
Hook
Filter
3
Batteries
each
Hook
Installation
1
plate
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available, provided
by installer)
Fixing bolt arrangement of outdoor unit
Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be
exposed to a strong wind.
Q'ty
Use Ø8 mm or Ø10 mm anchor bolts and nuts.
If it is necessary to drain the defrost water, attach drain nipple % and cap
water proof & to the bottom plate of the outdoor unit before installing it.
One
each
1
One
When using a multi-system outdoor unit, refer to the installation manual
provided with the model concerned.
2
For the rear left and bottom left piping
Cut out a piece of SPACER from indoor
unit packaging box, roll it and insert
between the indoor unit and wall to tilt
the indoor unit for better operation.
The auxiliary piping can be connected
to rear left, rear right, bottom right or
bottom left.
Shield pipe
Rear
right
Do not allow the drain hose to get slack.
Make sure to run the drain hose sloped
downward.
Refrigerant piping must be protected
from physical damage.
Install a plastic cover or equivalent.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
Wall
Bottom Rear
right left
Bottom left
Cut the piping
hole sloped
slightly.