Advertisement
★④ Position the light spot on the background of label
and when you press STATIC button 2 seconds,
Lamp "Delay" & "L/D" blink & flicker too.
⑤ Move the light spot to the mark(cutting line or figure, letters)
and when you press TEACH button, lamp delay,
L/D will be off and Q/T will stop blinking.
(This time, if Q/T continues to blink quickly, the contrast
is insufficient, Set it again.)
(Caution)
※ Whatever the background is darker or lighter than the mark, activate TEACH the
background first and the mark second.
※ After setting the sensor, do not press Delay, L/D button, it may happen an error
changing input data.
※ In the case of objects with reflective or shiny surface, tilt sensor by 10° to 15° relative
to surface.
E-mail : cutex@chol.com
- 4 -
http://www.cutex.kr
Advertisement
