Yamaha MT 10 Owner's Manual page 71

Tightening torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 13 lb·ft)
7. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
8. Refill with the specified amount of
the recommended engine oil.
TIP
Wipe off any spilled oil before starting
the engine.
9. Check the O-ring for damage, and
then install the oil filler cap.
Periodic maintenance and adjustment
1. Engine oil filler cap
2. O-ring
10. Start the engine and let it idle for
several minutes while checking for
oil leakage. If any leakage is
found, immediately stop the en-
gine and check for the cause.
TIP
After the engine is started, the oil pres-
sure warning light should go off if the oil
level is sufficient.
NOTICE
If the oil pressure warning light flick-
ers or remains on even if the oil level
is correct, immediately turn the en-
gine off and have a Yamaha dealer
7-13
check the vehicle.
11. Turn the engine off, wait a few min-
utes until the oil settles, and then
1
check the oil level one last time.
2
ECA20860
1
2
3
4
5
6
7
8
9
10
11
12