Yamaha MT 10 Owner's Manual page 35

shown.
To switch between the "km/L" and
"L/100 km", push the "CLOCK" and
"RESET" buttons at the same time.
TIP
If traveling at speeds under 20 km/h (12
mi/h), "– –.–" is displayed.
Average fuel consumption mode
1
1. Average fuel consumption display
This display shows the average fuel
consumption since it was last reset.
The average fuel consumption display
can be set to either "AVE – –.– km/L",
"AVE – –.– L/100 km" or "AVE – –.–
MPG" (when the multi-function meter
unit has been set to miles).
Instrument and control functions

"AVE – –.– km/L": The average
distance that can be traveled on
1.0 L of fuel is shown.

"AVE – –.– L/100 km": The aver-
age amount of fuel necessary to
travel 100 km is shown.

"AVE – –.– MPG": The average
distance that can be traveled on
1.0 Imp.gal of fuel is shown.
To switch between the "km/L" and
"L/100 km", push the "CLOCK" and
"RESET" buttons at the same time.
To reset the average fuel consumption,
push the "RESET" button for two sec-
onds.
TIP
After resetting the average fuel con-
sumption, "– –.–" will be shown until the
vehicle has traveled a sufficient dis-
tance.
4-14
Brightness and shift indicator light
control mode
1
1. Brightness level display
This mode cycles through five control
functions, allowing you to make the fol-
lowing settings in the order listed be-
low.

Screen brightness:
This function allows you to adjust
the brightness of the screen.

Shift indicator light style:
This function allows you to set the
indicator light to on, flash, or off.

Shift indicator light on r/min:
This function allows you to select
the engine speed at which the indi-
cator light will be activated.

Shift indicator light off r/min:
1
2
3
4
5
6
7
8
9
10
11
12