Table of Contents
Advertisement
LINE command
The LINE command informs the user about the status of the connection over the physical line. Upon
entering the <C> parameter, the updating of the information on the screen will occur automatically with the
interval of 5...20 seconds according to the parameter set by the TRACETIME command:
Line Port Statistics
-------------------------------------------------------------------------
Transmit Packets
Receive Packets
Receive Error Packets
Error Packet Rate, %
Receive Bytes
Transmit Bytes
Average Speed, kBps
-------------------------------------------------------------------------
Software Version
Link
Line Speed, kBps
Signal Level, dBm
Far-End Level, dBm
Noise Level, dBm
NTU_PM_S09_P1>
ETH command
The ETH command informs the user about the status of the connection over the Ethernet port. Upon
entering the <C> parameter, the updating of the information on the screen will occur automatically with the
interval of 5...20 seconds according to the parameter set by the TRACETIME command:
Ethernet Port Statistics
Speed
Link State
5
Octets
180
Ucast Packets
0
NUcast Packets
2
Discards Pckts
1
Errors
0
NTU_PM_S09_P1>
Date 21.10.03
LOCAL
5
sec
0
0
0
0.00
0
0
0
1.2
Down
272
0.0
63.0
-16.0
-16.0
100M
Link Up
Input
sec
Total
3810
0
33
6
0
page 15 of 29
Total
5
0
0
0
0
0
0
0.00
0.00
0
0
0
0
0
0
Down
272
0.0
0.0
63.0
0.0
0.0
Duplex Mode Full
5
sec
0
0
0
0
0
REMOTE
sec
Total
0
0
0
0.00
0
0
0
Output
Total
0
0
0
0
0
Advertisement
Table of Contents
