Table of Contents
Advertisement
2 Basic operation
2.1 First operation / self test
In case the MP 6.2 was not connected to mains a self test will be performed when it is
switched on by the mains switch (35) for the first time. The unit will check its configuration
and that all the installed components work properly. The procedure is shown in the display.
Afterwards the unit will switch to stand by.
2.2 Switching on / stand by
Using the button power (1) you can switch between on (operate) and stand by. When
switched on, the display (10) lights up and the LED (7) is off. In stand by mode the display is
off and the LED is on to indicate that the unit is still connected to mains.
CAUTION: When switched to stand by the unit is still connected to the mains. In case of a
thunderstorm or if you leave the house for a longer time we recommend that you switch the
amplifier off by using the mains switch (35) or pull the mains plug (34).
2.3 Display
When the unit is on, the display (9) shows information about the current settings and state of
your Media Player. Apart from informations about the operating status (CD Player, Digital
Input etc.) the lower line shows you currently active settings of the D/A converter: On the left-
hand side the sample rate (e.g. "192") and bit depth is displayed. On the right-hand side you
will find the current filter setting (SMOOTH or STEEP).
2.3.1 Display in CD player mode
TRACK
On the left-hand side both the current title is displayed (big figures) and the total number of
available tracks of the inserted CD (small figures).
TIME
At the centre of the display the total duration of an inserted CD is displayed, while stopped
(STOP). As soon as the CD is played (PLAY) or paused (PAUSE), the time already elapsed of
the current track is displayed.
STATUS
On the right-hand side the current operating status is displayed (STOP, PLAY, PAUSE).
13
Advertisement
Table of Contents
