Canon MB5400 SERIES Online Manual page 1037

#003 Document is too
long.
#005 No answer.
#012 No paper is in the re-
cipient's fax device.
#017 No tone is detected.
#018 Line was busy.
#022 Number is deleted.
#037 Memory is full.
#059 Transmission has
been canceled due
to a fax information
mismatch.
#085 Try again in black &
white transmission.
#099 The Stop button was
pressed during
transmission.
#412 The fax could not be
sent from the com-
puter.
#995 The unsent fax was
deleted while auto-
matic redialing.
You attempted to send a document longer than 15.75 inches / 400 mm.
You cannot send a document longer than 15.75 inches / 400 mm from the ADF.
"#003" is also printed if it takes time to send a page. Divide the document or set the
image quality (Fax resolution) to a lower setting, and then resend it.
The recipient's fax device does not respond.
Contact the recipient and have the recipient check that the telephone line is connected
correctly.
There is no paper in the recipient's fax device.
Contact the recipient and have the recipient load paper.
The printer could not detect the dial tone.
Dial tone detect in Advanced FAX settings under FAX settings is set to ON. Set to
OFF.
Advanced FAX settings
The fax/telephone number you dialed is busy.
Try dialing again after waiting for a moment.
The fax/telephone number registered in the printer's directory is incorrect.
Check the recipient's fax/telephone number, correct the fax/telephone number regis-
tered in the printer's directory, and then send the document again.
Changing Registered Information
The printer could not send a fax because its memory is full.
Delete contents in memory, and then send a fax again.
Document Stored in Printer's Memory
Transmission has been canceled because the printer could not detect the recipient's
fax device information or the information did not match the dialed number. This mes-
sage is displayed when Check RX FAX information in Security control under FAX
settings is set to ON.
For details, see Sending Faxes after Checking Information (Checking Recipient's Infor-
mation).
The recipient's fax device is not color-compatible.
Resend the document in black & white.
The Stop button was pressed to cancel transmission of the document. Resend it if
necessary.
The fax could not be sent from the computer. Ensure that the printer is connected with
the computer correctly and redo operation.
While automatic redialing, the unsent fax is stored in the printer's memory temporarily
until the sending fax is complete. If a power failure occurs or you unplug the power
1037