Unpacking; Requirements For The Installation Location; Sources Of Hazards - Graef UNA Instruction Manual

Always pull the supply line from the electric socket using the connector plug,
●
not on the connector cable.
Never operate the unit with wet hands.
●
This unit must be used with the carriage and food holder unless the size and
●
shape of the items to be sliced do not permit use of the food holder.
In stand-by mode, turn the control knob clockwise past the zero position up
●
to the limit so that the stop plate covers the cutter.
Do not use the packing material as a toy. Danger of suffocation.
●
Do not touch the blade with your fingers. It is very sharp and cause severe
●
injuries.
Make sure the unit is switched off and not connected to the mains supply.
●
Check to make sure the limit stop is closed (cutter blade is covered).
●
Do not use any aggressive or abrasive cleaning agents and do not use any
●
solvents.
Do not scratch off stubborn soiling with hard objects.
●
Do not wash in the unit in water or immerse it into water.
●

Unpacking

To unpack the unit, proceed as below:
Take the unit out of the carton.
●
Remove all pieces of the packing.
●
Remove any possibly extant labels on the unit (do not remove the rating
●
plate).

Requirements for the installation location

For safe and flawless operation of the unit, the place of location must meet these
prerequisites:
The unit must be set up on a firm, flat, level and non-slip base that has sufficient
load bearing capacity.
Select the place of location so that children cannot reach the sharp blade in
the unit.

Sources of hazards

The rotating blade can cut off body parts. Your fingers, especially the thumbs,
are endangered. For this reason, never reach into the space between the stop
plate and the holder for the material to be sliced as long as the stop plate is not
16