Table of Contents
Advertisement
15
Needle in needle hole centre
.06.07
Rule
The needle should pierce the centre of the needle hole exactly.
Fig. 15 - 08
O Switch the machine on.
O Set the stitch length to "0" using the control panel and turn the handwheel until the feed
regulator motor responds.
O Insert the needle into the needle hole by turning the handwheel.
O Loosen the screws 1,2 and 3
O Adjust the needle bar frame 4 according to the rule.
O Tighten the screw 2 and gently tighten the screw 3.
O Use the screw 1 to pull the internal guide pin up to the eye of the needle bar frame 4 and
tighten it.
O Turn the handwheel a few turns so that the needle bar frame 4 is not under tension.
O Tighten the screw 3.
O Switch the machine off.
Adjustment
1
4
2
3
13
Advertisement
Table of Contents
