Engine Maintenance; Accessing The Engine - Toro 25430 Operator's Manual

Figure 34
1. Grease fitting (upper)
2. Lift cylinder
3. Wipe up any excess grease.
1
2
3
g021793
3. Grease fitting (lower)

Engine Maintenance

Before maintaining the engine, perform the following steps:
1. Park the machine on level ground, lower all
attachments, and stop the engine.
2. Remove the ignition key and allow the engine to cool
for 2 or 3 minutes.

Accessing the Engine

Removing the Side Panels
1. If the optional backhoe is installed, perform the
following substeps to remove the left side panel;
otherwise, skip to step 2:
A. At the left side of the machine, remove the
retaining pin from the front end of the walkway
(Figure 35).
1. Retaining pin
B. Pivot the walkway away from the machine as
shown in Figure 35.
2. Pull up on the hand grip of the panel latch, and swing
the latch free from the anchor bracket (Figure 36).
36
Figure 35
2. Walkway