Rear Wheel - Yamaha 2007 V Star XVS650W Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

Rear wheel

To remove the rear wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Loosen the axle nut.
6
1. Axle nut
2. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the bolt and nut.
3. Loosen the brake torque rod nut at
the swingarm.
EAU25080 4. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
EAU25141
shaft lever.
EWA10820
1. Brake pedal free play adjusting nut
2. Brake camshaft lever
3. Bolt and nut (shoe plate)
4. Brake torque rod
5. Bolt and nut (swingarm)
6. Brake rod
5. Remove panel A. (See page 6-5.)
6. Remove the bolts that secure the
final gear case to the swingarm.
1. Bolt
2. Final gear case
7. Lift the rear wheel off the ground
8. While supporting the drive shaft,
NOTE:
Make sure to support the drive shaft as
it is being pulled out.
6-34
according to the procedure on
page 6-32.
pull the rear wheel back to remove
the following parts as an assem-
bly: wheel, wheel axle, final gear
case, and drive shaft.