Yamaha TT-R110E Owner's Manual page 73

1. Wheel axle
7. Remove the brake shoe assembly
from the wheel hub by pulling it
out.
1
1. Brake shoe assembly
8. Remove the wheel.
PERIODIC MAINTENANCE AND ADJUSTMENT
To install the front wheel
1. Install the brake shoe assembly
into the wheel hub.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
1. Slot
2. Retainer
3. Insert the wheel axle from the
right-hand side, and then install
the washer and the axle nut.
4. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
7-30
5. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
35 Nm (3.5 m·kgf, 25 ft·lbf)
6. Adjust the brake lever free play.
(See page 7-18.)
7. While applying the front brake,
push down hard on the handlebar
several times to check for proper
fork operation.
2
1
7