Error Messages - Kenwood DNX8160DABS Instruction Manual

Other
Problem
The Touch Sensor Tone doesn't
sound.

Error Messages

When you fail to operate the unit correctly, the cause of the failure appears as the message on
the screen.
Error Message
here is an error Protective circuit has been activated
in the speaker because a speaker cord has shorted
wiring. Please or it has come in contact with the
check the car chassis.
connections.
Hot Error When the internal temperature of
this unit rises to 60°C or more, the
protection circuit is activated and
you may not be able to operate
the unit.
Mecha Error The disc player is malfunctioning.
Disc Error An unplayable disc is inserted.
Read Error The disc is quite dirty.
Disc is upside down.
Region Code The disc you wanted to play has a
Error region code that cannot be played
with this unit.
Error 07–67 The unit is not operating correctly
due to some reason or other.
No Device (USB The USB device is selected as a
device) source although no USB device is
connected.
Disconnected The iPod/Bluetooth audio player
(iPod, Bluetooth is selected as a source although
audio player) no iPod/Bluetooth audio player is
connected.
No Media file The connected USB device contains
no playable audio file. Media was
played that doesn't have data
recorded that the unit can play.
Reason
The preout jack is being
used.
Cause
Solution
The Touch Sensor Tone cannot be output
from the preout jack.
Solution
Wire or insulate the speaker cord as
appropriate and turn the power off and on
again.
Use the unit again after reducing the
temperature of the unit.
Eject the disc and try inserting it again.
Contact the KENWOOD dealer if this indicator
continues blinking or the disc cannot be
ejected.
Change the disc.
Playable Media and Files
See
Clean the disc.
Precautions on handling discs
See
Load the disc with the labeled side up.
Region Codes in the World (P.114)
See
try another disc.
Turn the power off and on again. If the "Error
07−67" message does not disappear, see your
nearest KENWOOD dealer.
Change the source to any source other than
USB/iPod. Connect a USB device, and change
the source to USB again.
Change the source to any source other than
iPod/Bluetooth. Connect an iPod/Bluetooth
audio player, and change the source to iPod/
Bluetooth again.
Playable Media and Files (P.108)
See
try another USB device.
Troubleshooting
(P.108).
(P.4).
or
and
105