Remote Control Button - Panasonic CS-XZ7SKEW Service Manual

17.2.2 Operation mode during Heating Only Operation

The table below shows the operation mode comparison when Heating Only Operation Mode Activated and
Deactivated.
Operation
Mode
After 30s sampling, regardless of the indoor intake or
AUTO outdoor intake temperature judgment, the unit will run
Heating operation.
HEAT The unit will run Heating operation.
COOL The unit will stop and Power LED blinking.
DRY The unit will stop and Power LED blinking.
NANOE-G
The unit will stop and Power LED blinking.
Stand-alone
The unit will run Force Cooling Operation for
Force Cooling
X_CTRYTM [15] minutes
Force Heating The unit will run Force Heating operation.
The unit will turn ON by the timer and run Auto
AUTO Operation. After 30s sampling, regardless of the indoor
(with Timer) intake or outdoor intake temperature judgment, the unit
will run Heating operation.
HEAT The unit will turn ON by the timer and run Heating
(with Timer) Operation.
COOL The unit will not turn ON by the timer. Power LED
(with Timer) blinking.
DRY The unit will not turn ON by the timer. Power LED
(with Timer) blinking.
Cooling
The unit will stop and Power LED blinking.
Test Mode
Heating The unit will operate according to specify Heating test
Test Mode mode operation parameter.

17.3 Remote Control Button

17.3.1 SET Button

To check remote control transmission code and store the transmission code to EEPROM:
Press "Set" button continuously for 10 seconds by using pointer.
o
Press "Timer Set" button until a "beep" sound is heard as confirmation of transmission code changed.
o
17.3.2 RESET (RC)

To clear and restore the remote control setting to factory default.
Press once to clear the memory.
o
17.3.3 RESET (AC)

To restore the unit's setting to factory default.
Press once to restore the unit's setting.
o
17.3.4 TIMER ▲

To change indoor unit indicator's LED intensity.
Press continuously for 5 seconds.
o
17.3.5 TIMER ▼

To change remote control display from Degree Celsius (°C) to Degree Fahrenheit (°F).
Press continuously for 10 seconds.
o
Heating Only Operation Mode Activated Heating Only Operation Mode Deactivated
After 30s sampling, the unit will judge the operation
mode base on remote controller temperature setting and
Indoor Intake Sensor (New Auto Mode) or Outdoor
Intake Sensor (Old Auto Mode).
The unit will run Heating operation.
The unit will run Cooling operation.
The unit will run Cooling Dry operation.
The unit will run Nanoe-G Stand-alone operation.
The unit will run Force Cooling operation.
The unit will run Force Heating operation.
The unit will turn ON by the timer and run Auto
Operation. After 30s sampling, the unit will judge the
operation mode base on remote controller temperature
setting and Indoor Intake Sensor (New Auto Mode) or
Outdoor Intake Sensor (Old Auto Mode).
The unit will turn ON by the timer and run Heating
Operation.
The unit will turn ON by the timer and run Cooling
Operation.
The unit will turn ON by the timer and run Cooling Dry
Operation.
The unit will operate according to specify Cooling test
mode operation parameter.
The unit will operate according to specify Heating test
mode operation parameter.
97