Panasonic CS-XZ7SKEW Service Manual page 51

12.3.6 How to Take Out Front Grille
Please follow the steps below to take out front grille if
necessary such as when servicing.
1 Set the vertical airflow direction louvers to the
horizontal position.
2 Remove the 2 caps on the front grille as
shown in the illustration at right, and then
remove the 3 mounting screws.
3 Pull the lower section of the front grille
towards you to remove the front grille.
When reinstalling the front grille, carry out
above step 2 - 3 in the reverse order.
12.3.7 Disposal of Outdoor Unit Drain Water

If a drain elbow is used, the unit should be placed
on a stand which is taller than 3 cm.

If the unit is used in an area where temperature
falls below 0°C for 2 or 3 days in succession, it is
recommended not to use a drain elbow, for the
drain water freezes and the fan will not rotate.
12.3.8 Eco Sensor

Do not hit or violently press the sensor. This can
lead to damage and malfunction.

Do not place large objects near the sensor and
keep heating units or humidifiers away from the
sensors detection area. This may lead to sensor
malfunction.
12.3.9 Check the Drainage

Open front panel and remove air filters. (Drainage
checking can be carried out without removing the
front grille.)

Pour a glass of water into the drain tray-styrofoam.

Ensure that water flows out from drain hose of the
indoor unit.
12.3.10 Evaluation of the Performance

Operate the unit at cooling/heating operation
mode for fifteen minutes or more.

Measure the temperature of the intake and
discharge air.

Ensure the difference between the intake
temperature and the discharge is more than 8°C
during Cooling operation or more than 14°C
during Heating operation.
Vane
(Move the vane
to downward)
Drain elbow 7
Install the hose at an angle so that the
water smoothly fl ows out.
51
Screw
Front
grille
Cap
Hose
ECO SENSOR
Drain tray-styrofoam
Discharge air