Product Overview; Unfolding The Handle - Toro 38515 Operator's Manual

Product Overview

5
3
6
4
7
9
1. Discharge chute
2. Chute handle
3. Control bar
4. Handle
5. Control panel
2
1
4
1. Key switch
2. Primer
2
1
8
m-6199a
6. Knobs
7. Handle bolt (2)
8. Rotor blade
9. Fuel tank cap
3
m 5544
3. Recoil start
4. Choke lever
3351-827 Rev A
6
Setup

Unfolding the Handle

1. Cut the plastic tie that secures the control cable
to the handle.
Note: Hold the cable taut to ensure that it stays
disconnected at the bottom.
2. Loosen the knobs, pull out the handle bolts, and
rotate the upper handle to the operating position.
3. Hook the end
of the control
cable into the
bottom hole of
the control bar.
m-6105
4. Fully insert the handle bolts.
Important:
Ensure that you
do not pinch the
control cable.
5. Tighten the
knobs until they
are snug.
6. Adjust the control cable. Refer to Adjusting the
Control Cable on page 10.
m-6103a
m-6104a