Static Grounding Instructions (Oil-Based Materials) - Graco D Series Operation, Parts

•
To spray oil-based materials after
spraying water-based materials, flush
the system thoroughly with mineral spir-
its or a compatible oil-based flushing
solvent first. The solvent flowing out of
the drain tube should not contain any
water. When flushing with solvents
always follow Static Grounding
Instructions (Oil-Based Materials),
page 23.
•
To avoid fluid splashing back on your
skin or into your eyes, always aim gun
at inside wall of pail.
Static Grounding
Instructions (Oil-Based
Materials)
The equipment must be grounded to
reduce the risk of static sparking and
electric shock. An electric or static spark
can cause fumes to ignite or explode. An
improper ground can cause electric shock.
A good ground provides an escape wire for
the electric current.
Always use a metal pail for oil-based
materials requiring flushing with compatible
oil-based flushing solvents when sprayer is
flushed or pressure is relieved.
Follow local code. Use only conductive metal
pails, placed on a grounded surface such as
concrete.
3A3234E
Do not place pail on a non-conductive surface
such as paper or cardboard which interrupts
grounding continuity.
Always ground a metal pail: connect a
ground wire to the pail. Clamp one end to the
pail and the other end to a true earth ground
such as a water pipe.
To maintain ground continuity when
sprayer is flushed or pressure is relieved
hold metal part of spray gun firmly to the side
of a grounded metal pail, then trigger the gun.
Reference
ti24584a
ti25497a
23