Graco D Series Operation, Parts page 19

10. Flush until approximately 1/3 of the
flushing fluid is emptied from the pail.
11. Turn ON/OFF switch to OFF position.
NOTE: Step 12 is for returning paint in air-
less paint hose to paint pail. One 50 ft (15
m) hose holds approximately 1 quart (1 liter)
of paint.
12. To recover paint in hose:
a. Hold gun firmly to the paint pail.
b. Point gun into paint pail.
c. Disengage trigger lock.
d. Pull and hold gun trigger.
e. Place Prime/Spray valve in SPRAY
position.
ti27121a
f. Turn ON/OFF switch to ON position.
g. Continue to hold gun trigger until
you see paint diluted with flushing
fluid starting to come out of gun.
13. While continuing to trigger gun, quickly
move gun to redirect spray into waste
pail. Continue triggering gun into waste
pail until flushing fluid dispensed from
gun is relatively clear.
ti27151a
14. Turn pressure control knob to the low-
est setting.
3A3234E
15. Stop triggering gun. Engage the trigger
lock.
16. Place Prime/Spray valve in PRIME
position.
ti27120a
17. Turn ON/OFF switch to OFF position.
18. Clean filter. See Cleaning Insta-
™
Clean Fluid Filter, page 20.
19. Fill unit with Pump Armor
Storage, page 21.
Cleanup
ti25809a
™
fluid. See
19