Page_Zone Module: Paging Zone Settings - VTech ErisTerminal VSP716A Administrator And Provisioning Manual

page_zone Module: Paging Zone Settings

The paging zone settings allow you to define a maximum of 10 paging zones that the
VSP716A can use for multicast paging.
The paging zone parameters (except for page_zone.call_priority_threshold) follow the
format page_zone.x.[element], where x is the paging zone ID number, ranging from 1 to 10.
All the paging zone settings are included in the general configuration file.
Setting:
Description:
Values:
Setting:
Description:
Values:
Setting:
Description:
Values:
Setting:
Description:
Values:
Setting:
Description:
Values:
Configuration File Parameter Guide
VSP716A Administrator and Provisioning Manual
page_zone.x.name
Sets the paging zone name, which appears on VSP716A LCD for
outgoing and incoming multicast pages. A maximum of 15 characters is
allowed.
Text string
page_zone.x.multicast_address
Enter the multicast IP address that the VSP716A will monitor. The range
of valid IP addresses is 224.0.0.0 to 239.255.255.255.
IPv4, IPv6 or FQDN
page_zone.x.multicast_port
Enter the multicast port associated with the multicast IP. The range of
valid ports is 1 to 65535.
1–65535
page_zone.x.accept_incoming_page
Enables or disables the VSP716A from receiving incoming multicast
pages for that paging zone. If disabled, the VSP716A can make outgoing
multicast pages only.
0 (disabled), 1 (enabled)
page_zone.x.priority
Set the paging zone priority from 1 to 10. Zones with a priority higher than
another zone can interrupt the lower-priority zone's active page.
1–10
195
Default: Blank
Default: Blank
Default: Blank
Default:
1
Default: 5
Back to Contents