Pioneer VSX-1130-K Operating Instructions Manual page 110

13
3 Check on the screen whether or not an update file was found.
If "New version found." is displayed, the update file has been found. The version number and updating time are
displayed.
If "This is the latest version. There is no need to update." is displayed, no update file has been found.
4 To update, select OK.
The updating screen appears and updating is performed.
! The power turns off automatically once updating is completed.
Software Update messages
Status messages Descriptions
Try disconnecting then reconnecting the USB device or storing the update file again. If the error still
occurs, try using a different USB memory device.
FILE ERROR
No update file was found on the USB memory device. Store the file in the USB memory device's root
directory.
UPDATE ERROR 1 to
Turn the receiver's power off, then turn it back on and try updating the software again.
UPDATE ERROR 7
If this message flashes, updating has failed. Update via a USB memory device. Put the update file on a
Update via USB USB memory device and connect the device to the USB port. When the file is found, software updating
starts automatically.
UE11
UE22 Updating has failed. Use the same procedure to update the software again.
UE33
On Screen Display Setup
When the receiver is operated, its status (the input name, listening mode, etc.) is displayed superimposed over
the video output on the display. This status display can be turned off by switching this setting to OFF. The setting
can be made for the main zone and HDZONE, respectively.
! Default: ON (both the main zone and HDZONE)
1 Select 'On Screen Display Setup' from the Other Setup menu.
2 Select and set the main zone or HDZONE (VSX-1130 only) for which you wish to change the
setting.
3 Select the On Screen Display setting you want.
4 When you're finished, press RETURN.
You will return to the Other Setup menu.
Notes
! The on-screen display is only displayed for video output from the HDMI terminal.
! When the video input signal is a 3D signal, the on-screen display may not be displayed.
! The size of the characters displayed differs according to the output resolution.
Remote Control Mode Setup
VSX-1130 only
! Default setting: 1
This sets this receiver's remote control mode to prevent erroneous operation when multiple units of the receiver
are being used.
1 Select 'Remote Control Mode Setup' from the Other Setup menu.
2 Select the Remote Control Mode setting you want.
3 Select 'OK' to change the remote control mode.
4 Follow the instructions on the screen to change the remote control's setting.
See Operating multiple receivers on page 93
5 When you're finished, press RETURN.
You will return to the Other Setup menu.
ZONE Setup
VSX-1130 only
Switches the sub-zone setting.
1 Select 'ZONE Setup' from the Other Setup menu.
2 Select 'MAIN/HDZONE', then press ENTER.
3 Set the usage of the HDMI OUT 2 terminal.
! MAIN: Select this to output the same input source as in the main zone.
After setting this to MAIN, exit the home menu, then press OUT P. and select the terminal for HDMI output
(page 89 ).
! HDZONE (default): Use the HDMI output's multizone function (HDZONE) to output an input source different
from the one in the main zone (page 89 ).
4 Select 'OK', then press ENTER.
5 When you're finished, press RETURN.
You will return to the Other Setup menu.
110
The System Setup and Other Setup menus
.