Toshiba E-STUDIO352 Printing Manual page 308

6 Printing from Macintosh
1) Destination
This selects the output destination tray.
- Inner Tray — Select this when no finisher is installed.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
- Job Separator Upper — Select this to route the output to the upper tray of the Job Sep-
arator.
- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
Depending on the type of finisher installed and destination settings, stapling and hole
punching may not be performed.
Depending on the equipment settings, the paper may be delivered to a tray that cannot
carry out stapling or hole punching when "Auto" is selected as the "Destination" option.
For e-STUDIO452 Series and e-STUDIO453 Series, "Tray 1" and "Tray 2" can be
selected when the Hanging Finisher, Finisher (Type A), Finisher (Type B), or Saddle
Stitch Finisher are installed.
When the Finisher (Type B) is installed in the e-STUDIO452 Series and stapling is
enabled, select "Tray 2".
For e-STUDIO282 Series and e-STUDIO283 Series, "Tray 1" and "Tray 2" can be
selected when the Hanging Finisher is installed, and "Tray 1" can be selected when the
Saddle Stitch Finisher is installed.
When the optional Job Separator is installed, you can select "Job Separator Upper" and
"Job Separator Lower" instead of "Inner Tray".
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
306 Printing from Application on Mac OS 8.6 to 9.x